Step drilling and chamfer drilling

1. Chamfer drilling
2. Step drilling or step and chamfer drilling

Chamfer drilling

What is a chamfered hole?

A large number of all holes produced need a chamfer or at least some deburring. Some typical examples are screw and rivet holes.

There are a number of drills to choose from and, by using circular interpolation, even a turning or a milling tool can be used.

Solid carbide drills

A standard programme of drills for 45 ° chamfers adapted for different thread/tap holes up to hole depths 2-3 x D_C.

How to apply chamfer drilling

Normally, the same feed, f_n(mm/rev) should be used when the chamfer insert is cutting. This is important, especially when drilling a blind hole, because a reduction in feed can result in long chips from the drilling operation.

However, sometimes in long-chipping materials, feed adjustment may be necessary during the chamfering operation to prevent long chips from becoming wrapped around the drill.

f_n

drill

f_n chamfering

Step drilling or step and chamfer drilling

Another common type of hole is a stepped, or stepped and chamfered hole. Typical applications are components with countersunk screws or bolts.

Drilling stepped or stepped and chamfered holes

Step/chamfer holes in one pass

Solid carbide drills – available with steps and chamfers.

Stepped holes by drilling two holes

Solid carbide drills - choose drill according to hole size and depth.

Stepped holes by drilling and boring

Solid carbide drills – choose drill and boring tool according to hole size and depth.

Stepped holes by helical interpolation

The step diameter hole can be 2 x DC. Helical interpolation is a slow operation and should not be used for deep steps. Choose cutter according to hole size.

Non-rotating drill

Choose a standard drill and programme the tool path.

How to apply

Step/chamfer holes in one pass

The challenge when using a multidiameter tool is to achieve good chip breaking from all edges in the cut. In long-chipping materials, such as low carbon steels and stainless steels, the initial tests should be made in steps:

1. First, check chip formation from the drill
2. Check chip formation from step insert
3. Check chip formation from chamfer insert

Stepped holes by drilling two holes

First larger diameter, then smaller.

Always start drilling the large diameter to assure centering of drill point and avoid chipping of cutting edges.

When drilling the small diameter make sure that the drill point angle is equal to or smaller than the large drill to ensure that the point hits the workpiece first.

Stepped holes by drilling and boring

Start with drilling then boring.

Stepped holes by helical interpolation

See Milling to learn more about hole making with milling cutters.