Cutting data for parting and grooving
Speeds and feeds for parting and grooving
- Use correct feed rates for the insert and material
- Start at a low feed rate to ensure insert security and surface finish, then increase feed rate to improve chip breaking
- Run at a cutting depth larger than the corner radius if side turning. This will improve chip control
- Setting the cutting speed too low will result in inadequate tool life. Always run recommended cutting speed, vc m/min (ft/min)
Related information
Parting and grooving
Find the cutting tool for your specific task and get instant cutting data recommendations. Go... chevron_right
Parting and grooving
In parting and grooving, process security and productivity are two important aspects.... chevron_right
How to improve tool life in turning
The three main machining parameters when turning are speed, feed, and depth of cut.... chevron_right
Troubleshooting
Bad surface Use a short and stable tool Take away the chips - use geometry with... chevron_right
